Codan HF SSB series - Selecting the Operating Mode

To Next Page

To Previous Page

Using the transceiver

3-20 HF SSB transceiver user guide

Selecting the operating mode

The transceiver has six operating modes:

• Channel mode (the normal operating mode)

• Clarifier mode

• View Channel Options mode

• Free-Tune Receiver mode

• Setup mode

• View All Settings mode.

Channel mode allows you to perform most of the operating

procedures described in this user guide.

Clarifier mode allows you to adjust the quality of the audio

signal by varying the pitch of the received signal. See Using

Clarifier mode on page 3-30.

View Channel Options mode allows you to see the option

settings set up for each channel. See Using View Channel

Options mode on page 3-31.

In Free-Tune Receiver mode, you can set the transceiver to

receive signals on any one frequency within its operating

range. See Using Free-Tune Receiver mode on page 3-33.

Setup mode allows you to view and change settings that

control transceiver operation. Refer to the HF SSB

transceiver reference manual, Chapter 4, Using Setup mode

procedures.

View All Settings mode allows you to view all transceiver

settings without allowing you to change any. See Using View

All Settings mode on page 3-37.