Codan HF SSB series - Switching on the Transceiver

Using the transceiver
3-4 HF SSB transceiver user guide
Switching on the transceiver
If you have set up the transceiver with a Personal
Identification Number (PIN), you will need to enter this PIN
before you can use the transceiver.
For details on setting and cancelling the use of a PIN, refer to
the HF SSB transceiver reference manual, Chapter 9, PIN
setup.
If you forget your PIN, you will have to obtain a special
password from Codan to delete the PIN before you can
use the transceiver.
To switch on the transceiver:
Action Notes
1.
Press
On/Off
The power up messages are
shown briefly.
If no PIN needs to be entered,
the display shows the currently
selected channel:
149
2040
CALL
Rx.
USB
HI
Geneva Switzerland
Pwr
Is the transceiver asking
you for a PIN?
Yes  Step 2.
No  Step 4.
If a PIN needs to be entered,
the display shows:
ENTER
Enter Pin
– – – – – –
Using the transceiver
3-4 HF SSB transceiver user guide
Switching on the transceiver
If you have set up the transceiver with a Personal
Identification Number (PIN), you will need to enter this PIN
before you can use the transceiver.
For details on setting and cancelling the use of a PIN, refer to
the HF SSB transceiver reference manual, Chapter 9, PIN
setup.
If you forget your PIN, you will have to obtain a special
password from Codan to delete the PIN before you can
use the transceiver.
To switch on the transceiver:
Action Notes
1.
Press
On/Off
The power up messages are
shown briefly.
If no PIN needs to be entered,
the display shows the currently
selected channel:
149
2040
CALL
Rx.
USB
HI
Geneva Switzerland
Pwr
Is the transceiver asking
you for a PIN?
Yes  Step 2.
No  Step 4.
If a PIN needs to be entered,
the display shows:
ENTER
Enter Pin
– – – – – –