Codan HF SSB series - Page 154

Advanced features
HF SSB transceiver user guide 6-19
Command Meaning
SIDEBAND=USB
SIDEBAND=LSB
SIDEBAND=AM
Changes the sideband setting for the
current channel. If the channel does not
allow the sideband setting to be changed,
nothing happens. You can use the
abbreviations
SB
,
U
and
L
.
SIDEBAND?
Shows you the selected sideband setting
(
USB
,
LSB
or
AM
). You can use the
abbreviation
SB?
.
STATUSACK=<address>,
“<message>”,S
Sends a reply to acknowledge that a user
status call has been received. This
command is typically generated
automatically by equipment connected to
the transceiver. If you specify option
S
,
the call is sent silently with the
loudspeaker switched off.
STATUSCALL=<address>,
“<message>”,S
Sends one of the three types of status call:
a remote diagnostics call for message
“1”
,
a remote config call for message
“2”
, or a
user status call for any other message up
to 63 characters. If you specify option
S
,
the call is sent silently with the
loudspeaker switched off.
STATUSTIME=<timeout>
Sets the status call reply timeout in the
range 1–255 seconds. The transceiver
waits this time for connected equipment to
respond to a user status command before
sending a negative acknowledgment.
STATUSTIME?
Shows you the current setting of the status
call reply timeout in seconds.
Advanced features
HF SSB transceiver user guide 6-19
Command Meaning
SIDEBAND=USB
SIDEBAND=LSB
SIDEBAND=AM
Changes the sideband setting for the
current channel. If the channel does not
allow the sideband setting to be changed,
nothing happens. You can use the
abbreviations
SB
,
U
and
L
.
SIDEBAND?
Shows you the selected sideband setting
(
USB
,
LSB
or
AM
). You can use the
abbreviation
SB?
.
STATUSACK=<address>,
“<message>”,S
Sends a reply to acknowledge that a user
status call has been received. This
command is typically generated
automatically by equipment connected to
the transceiver. If you specify option
S
,
the call is sent silently with the
loudspeaker switched off.
STATUSCALL=<address>,
“<message>”,S
Sends one of the three types of status call:
a remote diagnostics call for message
“1”
,
a remote config call for message
“2”
, or a
user status call for any other message up
to 63 characters. If you specify option
S
,
the call is sent silently with the
loudspeaker switched off.
STATUSTIME=<timeout>
Sets the status call reply timeout in the
range 1–255 seconds. The transceiver
waits this time for connected equipment to
respond to a user status command before
sending a negative acknowledgment.
STATUSTIME?
Shows you the current setting of the status
call reply timeout in seconds.