Advanced features
HF SSB transceiver user guide 6-21
Message Meaning
GPS-POSITION:
<channel number>,
<address of other station>,
<your address>,<time of call>,
<GPS position>
You sent a GPS beacon call or received a
GPS position call from the station at this
GPS position.
MUTE:OFF
MUTE:SELCALL
MUTE:VOICE
A control panel was used to change the
mute setting.
NO ALPHA SELF ID
You tried to send an ALE call to an
alphanumeric address but your own
alphanumeric address is unset.
NO EXTERNAL UNIT
CONNECTED
You sent a user status call to a station that
is not connected to a computer.
NO RESPONSE
Your call has not been acknowledged.
NOT FOUND
Non existing channel number or scan
table number.
OK
Command accepted and executed.
PAGE-CALL-ACK:
<channel number>,
<address of other station>,
<your address>,<time of call>
Your page call was received.
PAGE-CALL:<channel number>,
<address of other station>,
<your address>,<time of call>,
“<message>”
You received a page call with this
message.
SCAN TABLE EMPTY
Attempt to start scanning using a scan
table that has not been set up.
Advanced features
HF SSB transceiver user guide 6-21
Message Meaning
GPS-POSITION:
<channel number>,
<address of other station>,
<your address>,<time of call>,
<GPS position>
You sent a GPS beacon call or received a
GPS position call from the station at this
GPS position.
MUTE:OFF
MUTE:SELCALL
MUTE:VOICE
A control panel was used to change the
mute setting.
NO ALPHA SELF ID
You tried to send an ALE call to an
alphanumeric address but your own
alphanumeric address is unset.
NO EXTERNAL UNIT
CONNECTED
You sent a user status call to a station that
is not connected to a computer.
NO RESPONSE
Your call has not been acknowledged.
NOT FOUND
Non existing channel number or scan
table number.
OK
Command accepted and executed.
PAGE-CALL-ACK:
<channel number>,
<address of other station>,
<your address>,<time of call>
Your page call was received.
PAGE-CALL:<channel number>,
<address of other station>,
<your address>,<time of call>,
“<message>”
You received a page call with this
message.
SCAN TABLE EMPTY
Attempt to start scanning using a scan
table that has not been set up.