Code Reader 2500 User Manual

C004386_03_CR2500_ User_Manual - 31
Save Settings
2.11.1 - Continuous Scan - Sleep Time Out
Scan one of the codes below to set the amount of time a cabled CR2500 will operate in continuous scan mode before
entering sleep mode:
Cabled - 2 hours Cabled - Always (Default)
Scan one of the codes below to set the amount of time an uncabled CR2500 will operate in continuous scan
mode before entering sleep mode:
Uncabled - 5 minutes (Default) Uncabled - 15 Minutes Uncabled - 30 Minutes
Note: This function is only recommended for short term use because of battery consumption.
2.11.2 - Continuous Scan - Trigger Delays
Scan the following codes to set delay time between scans:
0 Seconds (Default) 1 Second 3 Seconds
2.11.3 - Continuous Scan - Duplicate Scan Suppression
Scan the following codes to set the period of time during which duplicate codes are ignored:
0 Seconds (Default) 1 Second 3 Seconds
2.11 - Continuous Scan Settings
2.12 - Motion Detection Scan Settings
Scan the following codes to set the reader to read when it detects motion in its scanning zone:
Motion Detection On Motion Detection Off

Code Reader 2500 Specifications

General

Brand	Code
Model	Reader 2500
Category	Barcode Reader
Language	English