C004386_03_CR2500_User_Manual - 52
Save Settings
7.1 - Reset Reader to Factory Defaults
Scan the following codes to reset reader:
Step 1: Reset the Reader
Reset to USB Factory Reset to PS/2 Factory Reset to RS-232 (Serial) Factory
Default Settings Default Settings Default Settings
Reset to RF One Way
Factory Default Settings Bootloader Mode
-
Step 2: Save Settings
Step 3: Clear All CodeXML Rules
Prefi x & Suffi x Clear All Stored Data
7.2 - General Safety Information
Repairs and Adjustments - Only those individuals authorized by Code should attempt to make repairs or adjustments to
CR2500 equipment. If the reader casing is opened the warranty is voided.
Power Supply - Use only the power supply provided for use with each specifi c reader when operating Code equipment.
Accessories - Only those accessories approved by Code (see page 2) should be utilized with Code equipment.
Non-compliance with any of the above may result in:
• Injury to individuals handling the equipment;
• Damage to the equipment; and
• Voiding of the maintenance contract.
Lithium Ion Battery - Warning: Charge the battery with Code cables ONLY. Do not open battery, dispose of in fi re, or
short circuit - it may ignite, explode, leak, or get hot causing personal injury.
Bootloader mode is
utilized to download new
version of bootloader
fi rmware.
Note: If you scan these codes, you
may lose your current settings. Make
sure to save settings on your reader
before scanning the reset codes.
To Next Page
Loading...
