Code Reader 2500 - Erase Prefi X and Suffi X Settings; Reader Text Commands

C004386_03_CR2500_User_Manual - 50
Save Settings
6.2 - Suffi x Settings (continued)
Suffi x - Tab Suffi x - Tab Suffi x - Erase
6.4 - Reader Text Commands
Enabling Reader Text Commands allows the CR2500 to accept text commands via RS-232 (Serial) or RF communication.
Scan the following codes to enable/disable reader text commands:
Reader Text Commands On Reader Text Commands Off - Default
6.3 - Erase Prefi x and Suffi x Settings
Scan the following codes to erase all prefi x and suffi x data.
Erase Prefi x & Suffi x Data
Note: Text commands can only be sent to the reader when it is active. See Reader-Host Interface Document for more
information.
(Keyboard Mode)
(Serial)