Precautions
Observe these precautions when installing the Cognex product, to reduce the risk of injury or equipment damage:
l This device requires the use of an LPS or NEC class 2 power supply (non-PoE device) or the use of a PoE Class
1 (PoE device).
l Do not connect or disconnect this device from the I/O module or 15-pin USB adapter cable while the I/O module
or adapter cable is connected to a PC .
l To reduce the risk of damage or malfunction due to over-voltage, line noise, electrostatic discharge (ESD), power
surges, or other irregularities in the power supply, route all cables and wires away from high-voltage power
sources.
l Changes or modifications not expressly approved by the party responsible for regulatory compliance could void
the user’s authority to operate the equipment.
l Cable shielding can be degraded or cables can be damaged or wear out more quickly if a service loop or bend
radius is tighter than 10X the cable diameter. The bend radius must begin at least six inches from the connector.
l This device should be used in accordance with the instructions in this manual.
l All specifications are for reference purpose only and may be changed without notice.
54
Precautions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
