Installing a Liquid Lens
Perform the following steps to install a liquid lens on your DataMan 260 reader.
Note: Disconnect the DataMan 260 reader from power before installing the liquid lens.
1. Remove the front cover: unscrew the four M2x12mm Phillips Pan screws and take off the LEDcover.
2. Remove the illumination module.
3. Turn the lens cap to the 105 mm position.
4. Remove the lens cap from the imager lens by pulling it.
Note: Do not rotate the imager lens while the lens cap is removed. Otherwise, focus calibration will be lost.
23
Setting Up Your DataMan 260
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
