Regulations/Conformity
The DataMan 260 has Regulatory Model 1AA5 and meets or exceeds the requirements of all applicable standards
organizations for safe operation. However, as with any electrical equipment, the best way to ensure safe operation is to
operate them according to the agency guidelines that follow. Please read these guidelines carefully before using your
device.
Manufacturer:
Cognex Corporation
One Vision Drive
Natick, MA 01760 USA
Regulator Specification
USA FCC 47 CFR Part 15 Subpart B, Class A
Canada
ICES-003
European Community
EN55022 (CISPR 22) Class A
EN55024
EN60950
Australia
C-TICK, AS/NZS CISPR 22 / EN 55022 for Class A Equipment
Japan
VCCI V-3/2015.04 Class A
Note: For the most up-to-date CE declaration and regulatory conformity information, please refer to the Cognex
online support site: http://www.cognex.com/Support.
CAUTION: This device requires the use of a PoE Class 1 or 48V DC LPS power supply.
CAUTION: IP protection is ensured only when all connectors are attached to cables or shielded by a sealing cap.
Safety and Regulatory
European
Compliance
WARNING: This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
The CE mark on the product indicates that the system has been tested to and conforms with the
provisions noted within the 2014/30/EU Electromagnetic Compatibility Directive. For further information
please contact: Cognex Corporation, One Vision Drive Natick, MA 01760 USA.
Cognex Corporation shall not be liable for use of our product with equipment (i.e., power supplies,
personal computers, etc.) that is not CE marked.
FCC Class A
Compliance
Statement
FCC Part 15, Class AThis device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference; and (2) this device must
accept any interference received, including interference that may cause undesired operation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at their own expense.
Canadian
Compliance
This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe
A est conforme à la norme NMB-003 du Canada.
C-Tick
Statement
Conforms to AS/NZS CISPR 22/ EN 55022 for Class A Equipment.
55
Regulations/Conformity
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
