ECON-4 1.4.0 Global Guide
53
Setpoint group Engine RPM Related FW 1.4.0
Range [units] Start RPM - Nominal RPM
Default value 350 RPM Force value NO
Step 1 RPM
Comm object 7189 Related applications ALL
Setpoint visibility Always
Description
If ECON-4 detects speed higher then Starting RPM, it terminates the starting sequence end starts normal
speed regulation.
Starting RPM
Note: ECON-4 can work only if Starting RPM < Idle RPM < Nominal RPM. If this condition is not met, ECON-4
activates bit Invalid setpoints in Transmit PDO 1, see description of CAN protocol. It is not possible to run the
engine if the bit Invalid setpoint is signalized.
6 back to List of setpoints
8.1.5 Group: Main PIDGroup: ECON-4-MainPID
Setpoint group Main PID Related FW
1.4.0
configured ECON-4 extension
module
Range [units] 0.0 – 200.0 %
Default value 10% Force value NO
Step 0.1 %
Comm object 7176 Related applications ALL
Setpoint visibility Always
Description
Gain of the PID speed regulation loop.
Speed gain
Note: Setpoint is active for unloaded engine.
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
