ComAp Inteli Mains NTC BaseBox User Manual

Communication Guide, ©ComAp – March 2014 103
IGS-NT Communication Guide 03-2014.pdf
Enter password
Password setting command. Password has to be set before adjusting of protected setpoint or
calling protected gen-set control command. Setting password command is not necessary
before every adjusting. Password is a number in range 0 to 65535 and is valid for all rest of
SMS.
Syntax: p PPPP (or pPPPP)
p … command
PPPP… password
Example: #5:accesscode p 1234, w 8252 144
Setting password before adjusting protected setpoint.
Return code: ok … setting password was successful
er_pass … setting password is not valid
Gen-set control
SMS command for invoking gen-set control command as Start, Stop, Fault reset etc.
Syntax: c Y (or cY)
c … command
Y … type of operation
Y
Type of operation
Y
Type of operation
1
Start
7
MCB ON
2
Stop
8
MCB OFF
3
Horn Reset
9
GCB ON/OFF
4
Fault Reset
10
MCB ON/OFF
5
GCB ON
11
Next Mode
6
GCB OFF
12
Previous Mode
Example: #5:accesscode p 1234, c1
This SMS command invokes gen-set Start. Password setting is needed in
case of password protection was configured for gen-set commands.
Return code: ok … gen-set command was accepted
er_pass … valid password was not set before executing the
command
c? … unknown gen-set command
c_er … gen-set command execution is not allowed in actual state
(e.g. attempt to start the gen-set in OFF mode).
er_old … command was read out from SMS during GSM modem
initialization – in this case command will not be served.
Read Alarm list
Read actual Alarm list.
Syntax: a
a … command
Example: #5:accesscode a
Request of actual Alarm list.
Return code: AL=(items of alarm list) … comma separated items of Alarm list.
Exclamation mark in front of Alarm list item indicates inverse record (still
active alarm).

ComAp Inteli Mains NTC BaseBox Specifications

General

Brand	ComAp
Model	Inteli Mains NTC BaseBox
Category	Controller
Language	English