InteliVision 5-1.1 Reference Guide ©ComAp – December 2011 4
Introduction
InteliVision 5 is the 5,7” colour display unit for ComAp InteliGen-NT, InteliSys-NT and InteliMains-NT
controllers. It is designed as a Plug and Play solution and it presents simple solution with high visibility
of all engine and gen-set data, monitoring information in colourful direction.
The new screens correspond to wide variety of daily usage and offer significant step ahead.
The compact size, robustness and user-friendly design introduce valuable solution for every day
usage where more information on the screen and display size is preferred alternative.
The same cut-out across all Comaps’ products helps InteliVision 5 to be easily used as a replacement
of or alternative to IG-Display. Regardless of the size it can be also used as an alternative to IS-
Display or InteliVision8.
InteliVision 5 is designed to be connected to the single controller only.
InteliVision 5 is offered in two hardware modifications:
• a local display unit (InteliVision 5)
• a remote version (InteliVision 5 RD) - unit with galvanic separated RS-485, analogue input and
binary output and internal buzzer.
InteliVisoin 5 and InteliVision 5 RD differ only by HW. All SW features, setting and programming are
the same for the both versions.
To Next Page
Loading...
Need help?
General
