Comcast CGA4332COM - Mark Computers as Trusted for All Services; Managed Devices

CBR2 CGA4332COM- User Guide
36 of 51
How to create a service rule
1. Go to the Admin Tool (http://10.1.10.1), using a computer or other device that is currently connected
to your Gateway (either wired or wirelessly). For more information, see “Accessing the Admin Tool”
.
2. In the Content Filtering menu, select Managed Services.
3. The Managed Services page appears.
4. In the Enable Managed Services list, select Enable.
5. In the Blocked Services table, click + ADD.
6. The Add Service to be Blocked page appears.
7. Complete the following fields:
 In the User Defined Service box, type a name for the rule (for example, FTP).
 In the Protocol list, click on the protocol used (for example, TCP).
 In the Start Port box, type the start port of the port range (for example, 21).
 In the End Port box, type the end port of the port range. If the service only uses one port, enter the
same value as in the Start Port box (for example, 21).
If the port range is not a continuous range of numbers, you must create multiple service rules.
8. If you want the rule to be applied only at specific times, click No in the Always Block list and define
when to apply the rule:
 Under Set Block Time, enter a start time and end time.
 Under Set Block Days, select the days for which the selected block time should be applied.
If you want to have different time schedules depending on the day, you must create separate rules:
• One rule for weekdays (for example, block the service from 10:00 PM until 8:00 PM).
• One rule for the weekend (for example, block the service from 10:00 PM until 8:00AM).
9. Click SAVE.
Mark computers as trusted for all services
When a device is marked as trusted, all managed services rules will be ignored.
To mark a device as trusted, proceed as follows:
1. Under Trusted Computers, look for your device and click Yes in the Trusted column.
2. The device is now able to use all web services unless prevented by other parental control functions that
you configured.
6.1.3 Managed devices
On the Managed Devices page, you can create a device-specific rule to prevent a device from accessing your
network.
Optionally, you can provide a time schedule for a rule. The rule will then only be activated during
the time you define.
Procedure
1. Go to the Admin Tool (http://10.1.10.1), using a computer or other device that is currently connected
to your Gateway (either wired or wirelessly). For more information, see “Accessing the Admin Tool”
.
2. On the Content Filtering menu, click Managed Devices.
3. In the Enable Managed Devices list, click Enable.