29
- the probes and steriliser grounding, as correct steriliser operations depend on the
correct grounding connection.
If the steriliser is not used for a long period, empty out the tanks and clean them carefully
with a cleaning solution (70% water and 30% alcohol). Do NOT use this solution for cycles.
Rinse out with plenty of water before any further operation. The
waste water recovery
tank 11 can be filled without removing any parts. Simply connect a pipe to the waste
water drain tap 25 and hold the fluid container higher than the steriliser. The tank can be
filled by removing the panelling and detaching one of the two pipes on top.
Waste water recovery tank 11
on models 24
Waste water recovery tank 11
on models 18
Messages
To Next Page
Loading...
