49
Automatic water inlet and direct drain system installation
This accessory may be fitted after installing the steriliser and it includes both the automatic
water inlet 29 and direct drain system 30. These systems are the same for all models: only
the tube length and arrangement changes.
• Pull out the steriliser (if built-in), place it in an appropriate position and remove the
cover.
• Remove plugs (T) from the lower part of the steriliser (right-hand side).
• Fit the plastic fitting on the larger hole used for draining.
• Fit the fittings and the hose holders for the automatic water inlet 29 on the smaller
hole. Direct the hose holder towards the drain.
Automatic filling
To Next Page
Loading...
