Error Message
LOAD
NOT INPUT
FILE
NOT OUTPUT
FILE
VERIFY
Cause and Suggested Remedies
An
unacceptable number of tape errors
were accumulated
on
a tape load (more than
31)
that
were
not
cleared
on
reading the
re-
dundant block. This message
is
issued in con-
nection
with
the
LOAD
command
(see
Chapter
4).
An
attempt
was made to read from a file
that
has been opened for
output
only.
Check the
READ#
and
OPEN
statement
parameters for correctness. Reading requ ires a
zero
as
the third parameter of the
OPEN
state-
ment
lthis
is
the default option).
An
attempt
was made
to
write
to a file
that
has been opened for input only.
Check the PRINT# and
OPEN
statement
parameters for correctness.
Writing
to a file
requires a 1 (or a 2 if vou
want
an
EOT
at the
end
of
the fi
le)
as
the third parameter in the
OPEN
statement.
The program in memory and the specified
file do
not
compare. This message
is
issued in
connection
with
the
VERIFY
command
(see
Chapter
4).
367
To Next Page
Loading...
