This section describes how to determine if the computer‟s blue tooth is functioning
properly. Figure 6-13 outlines the process. Perform the steps below starting with
Procedure 1 and continue with the other procedures as required.
Procedure 1: blue tooth connection check
Procedure 2: blue tooth replacement check
14.1 Procedure 1 blue tooth connection check
The blue tooth is connected by the blue tooth cable to the system board. Make sure
the blue tooth cable is firmly connected to the blue tooth device and system board.
Replacement Procedures, for instructions on how to disassemble the computer and
then perform the following checks.
If any of the connections are loose, reconnect firmly. If any of the connections is
damaged, or there is still an error, go to Procedure 2.
14.2 Procedure 2 blue tooth replacement check
The blue tooth device or cable may be defective or damaged.
To Previous Page
Loading...
