3-10 Compaq 1000 Series UPS Operation and Reference Guide
Returning to Standby Mode
When the UPS is in Operate mode (LED 16,
1
, is green), pressing the
STANDBY button (
2
) will place the UPS in Standby mode. The UPS will
acknowledge compliance with a short beep. LED 16 (
1
) will extinguish, and
power to the loads will cease.
2
1
Figure 3-4. Standby mode controls
1
ON LED
2
STANDBY button
IMPORTANT:
■ While in Standby mode, the UPS maintains the charge on the batteries, but no power
is available at the output receptacles.
■ The UPS remains in Standby mode until an alternate mode is selected, or until utility
power is removed.
To Next Page
Loading...