Reference Guide 7-25
Writer: Your Name Saved By: Alyce Klingler-Castle Saved Date: 06/13/97 5:49 PM
Pages: 36 Words: 4809 Template: c:\msoffice\templates\comm.dot
File Name Ch7.doc Part Number 270844-001
Because your computer comes preconfigured, cable
configuration does not become a consideration until you decide
to add an optional SCSI device.
1 Computers with 2-peripheral SCSI cables (without
termination) must have termination enabled on the last
device.
2 Computers with 3- and 4-peripheral SCSI cables come with a
terminator 3 on the end of the cable. The connector on the
opposite end of the cable always connects to the system
board. All SCSI devices connected with these cables must
have their termination disabled.
✎
4X and 8X devices may not have terminating jumpers on
the device. Termination on these devices must be
achieved with terminated cable.
For additional information about installing optional SCSI
devices, refer to the documentation that comes with the device
or contact your Compaq authorized dealer, reseller, or service
provider.
To Next Page
Loading...
