EasyManua.ls Logo

Comtrol DeviceMaster LT - Uploading the Firmware

Comtrol DeviceMaster LT
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DeviceMaster LT User Guide: 2000586 Rev. B
RedBoot Procedures - 105
Uploading the Firmware
5. Restart iptables to pick up the changes from Steps 3 and and 4:
/sbin/service iptables restart
6. Add the proper lines to /etc/hosts.allow:
in.tftpd: 192.168.250.250
7. Go to Uploading the Firmware on Page 105 to load the firmware.
Uploading the
F
irmware
This Linux procedure requires that a TFTP server is installed.
1. Verify that you have the .b
in file (Locating Software and Documentation on
Page 9) and place the .bin file in /tftpboot so that you can retrieve it with the
DeviceMaster LT.
2. Open a telnet session, enter the DeviceMaster LT IP address.
3. Press the Enter k
ey, if you did not program a password or type the password
and press Enter.
Note: The DeviceMaster LT does not come pre-programmed with a password.
4. Type re
set, and close the session.
5. Open a new telnet session and enter the DeviceMaster LT IP address.
6. Enter the webserver password and Enter,
or press Enter if a password has not
be
en set up.
7. At the Re
dBoot > prompt: type dis and press Enter to disable the Bootloader.
8. Verify that the system responds with an Load
ing disabled message.
9. Load the file from a TFTP server using
the following command and then press
Enter:
load -r -b 0x28000000 -h <TFTP-Server_
IP_Addr> <Downloaded_File_Name>
10. When the RedBoot> prompt appears (after approx
imately one minute if you
are uploading the Bootloader and approximately three minutes if you ware
uploading SocketServer, type go.
If uploading Bootloader:
In a few seconds the ethernet and Status LED cycle
through a light sequence once and
the update is complete.
$ telnet 192.168.250.250
Trying 192.168.250.250...
Connected to 192.168.250.250.
Escape character is ‘^]’.
DefaultIPAddress
Password:
*********************************************
**
** Comtrol DeviceMaster Bootloader Version 3.23
** RedBoot(tm) environment - built 18:59:20 Oct 13 2011
** Platform: Comtrol DeviceMaster (ARM 7TDMI)
** Portions Copyright (C) 2000. Red Hat, Inc.
** Portions Copyright (C) 2001-2008 Comtrol Corp.
*********************************************
FLASH: 64 blocks of 65536 bytes each
FLASH: 4194304 bytes (0x05000000 - 0x05400000)
RAM: 8126464 bytes (0x00000000 - 0x007c0000)
RedBoot>
RedBoot>dis
Loading disabled
RedBoot>go

Table of Contents

Related product manuals