Comtrol DeviceMaster LT - Example 1; Example 2

60 - DeviceMaster LT Security
DeviceMaster LT User Guide: 2000586 Rev. B
Example 1
Example 1 The following example shows how to monitor output using a loopback plug and a
program that repeatedly sends the string abcABC123 to Port 1:
dm> monitor 1
Serial monitoring started for port 1 -- press [Enter] to stop.
> 61 62 63 41 42 43 31 32 33
< 61 62 63 41 42 43 31 32 33
> 61 62 63 41 42 43 31 32 33
< 61 62 63 41 42 43 31 32 33
> 61 62 63 41 42 43 31 32 33
< 61 62 63 41 42 43 31 32 33
> 61 62 63 41 42 43 31 32 33
< 61 62 63 41 42 43 31 32 33
Example 2 The following example shows how the -a option enables displaying of ASCII
representation of data in a column to the right the hex representation:
dm> monitor -a 1
Serial monitoring started for port 1 -- press [Enter] to stop.
> 61 62 63 41 42 43 31 32 33 > abcABC123
< 61 62 63 41 42 43 31 32 33 < abcABC123
> 61 62 63 41 42 43 31 32 33 > abcABC123
< 61 62 63 41 42 43 31 32 33 < abcABC123
> 61 62 63 41 42 43 31 32 33 > abcABC123
< 61 62 63 41 42 43 31 32 33 < abcABC123
> 61 62 63 41 42 43 31 32 33 > abcABC123
< 61 62 63 41 42 43 31 32 33 < abcABC123
> 61 62 63 41 42 43 31 32 33 > abcABC123
< 61 62 63 41 42 43 31 32 33 < abcABC123
> 61 62 63 41 42 43 31 32 33 > abcABC123
< 61 62 63 41 42 43 31 32 33 < abcABC123
(Continued
from the
previous page)
Enable
Monitoring
Secure Data via
Telnet
• securemon [enable|disable]
By default, monitoring of TX/RX data when in Secur
e Data
Mode i
s not allowed through telnet (an insecure protocol).
This command allows you to override that default wh
en
secur
emon is enabled it will allow monitoring of secure data
via an insecure protocol like telnet.
Currently, because of issues with the DeviceMaster LT
ssh
implemen
tation, monitoring serial port data via
the ssh
comma
nd-line interface is not supported. It is expected th
at
i
t will be supported in the future. Once it is supported, th
e
secur
emon setting will not affect th
e ability to monitor secure
d
ata via ssh (which will always be allowed).
Enable Telnet/ssh
This option
enables or disables the telnet security feature after
you click Save and the DeviceMaster LT has been rebooted. This
option is enabled by default.
Enable SNMP
This option enables or disables the SNMP security feature after
you click Save and the DeviceMaster LT has been rebooted. This
option is enabled by default.
Security
Option
Description