DeviceMaster LT User Guide: 2000586 Rev. B
Device Driver (NS-Link) Installation - 39
Enabling Secure Data Mode
6. Click Apply to save these changes.
Note: If you selected RS
-422 mode, make sure that there is not a device
attached to the port
and click Ok.
7. Highlight the next port that you want to configure and perform
Steps 1
through 6.
8. Refer to
Connecting Serial Devices on Page 43 to attach your serial device.
9. Optionally, you may need to configure one
or more ports for socket mode
(Socket Port Configuration on Page 41).
Enabling Secure Data Mode
In addition to enabling SSL mode in the driver, you must Enable Secure Data Mode
in the NS-Link web page. Use the following procedure to implement the Enable
Secure Data Mode option.
1. Access the NS-Link web page using one of these methods:
• Open your web browser, enter the IP address, and press Enter.
• Right-click the DeviceMaster in the Device List pane in PortVision DX an
d
click Webpage.
2. Click the Security tab
.
3. Click Enable
Secure Data Mode and Save.
4. Configure your security key and certificate and click Set
.
Click the Help button if you need information about key and certificate
management.
To Next Page
Loading...
