DeviceMaster LT User Guide: 2000586 Rev. B
Managing the DeviceMaster LT - 79
Using Driver Configuration Files
Using Driver Configuration Files
This subsection discusses how to create (save) and load driver configuration files.
You may want to create driver configuration files for these reasons:
• Save the driver configuration settings so that you can load them on simila
r
De
viceMaster LTs to save configuration time
• Save the driver configuration settings b
ecause you need to remove a driver
version to install a new driver version and you want to reload the driver
configuration settings into the new driver
Saving Driver
Configuration F
iles
You must save the driver configuration file in portions:
• Device-level configuration parameters.
• Port configuration parameters. You must upload each port's configuratio
n
parameters s
eparately
.
Saving Device-Level
Configuration
Use the following procedure to create and save a configuration file.
1. If necessary, open the C
omtrol Drivers Management Console using one of these
methods:
• Windows Control Pan
el; go to your Control Panel and click the Comtrol
Drivers Management Console.
• Sho
rtcut; located under Start> Program Files> Comtrol> DeviceMaster LT>
Comtr
ol Drivers Management Console.
2. Depending on your operating system
, you may need to click Yes to the Do you
wa
nt to allow the following program to make changes to this computer? User
Account Control message.
3. Highlight the DeviceMaster LT for which you want to save the driv
er
conf
iguration.
4. Click Sa
ve Configuration.
To Next Page
Loading...
