Comtrol DeviceMaster LT - Page 108

108 - RedBoot Procedures
DeviceMaster LT User Guide: 2000586 Rev. B
RedBoot Command Overview
mcopy -s <location>
-d <location> -l <length>
[-1|-2|-4]
Copies memory from one address to another.
mfill -b <location> -l <length>
-p
<pattern> [-1|-2|-4]
Fills a block of memory with a pattern.
model† Shows model number.
password {password} Sets or deletes the password.
ping [-v] [-n <count>]
[-
l <length>] [-t <timeout>]
[-r <rate>]
[-i <IP_addr>] -h <IP_addr>
Network connectivity test.
reset Resets the DeviceMaster LT.
secureconf [disable|enable] Sets or displays secure config enable.
securedata [disable|enable] Sets or displays secure data enable.
? Displays short help.
snmp [disable|enable] Sets or displays SNMP enable.
telnet [disable | enable} Sets or displays telnet server enable. Disables telnet.
teltimeout [seconds] Shows or sets telnet time-out.
terse Terse command response mode.
timeout {seconds} Displays or sets Bootloader time-out value.
version Displays RedBoot version information.
x -b <location> [-l <length>] [-s]
[-1|2|4]
Displays (hex dump) a range of memory.
† Do not use these commands to change the values. Doing so
would cause the DeviceMaster LT to
stop functioning.
RedBoot Commands (Continued)