Conel FLOW - Storage Conditions and Security; Storage Security and Liability; Recommended Storage Environment; Installation Environment and Setup

65
6 STORAGE
6.1 SECURITY
Note:
• The manufacturer assumes no liability or warranty for personal injury or damage to
the Conel Flow Rain-Champion caused by incorrect storage conditions.
6.2 STORAGE
• Storage temperature: - 15 °C to +55°C;
• The Conel Flow Rain-Champion must be kept dry in a dry place away from heat sources;
• Be protected from dirt/dust and vibrations;
• Do not expose to direct sunlight.
7 SETTING UP CONDITIONS
7.1 SECURITY
ATTENTION: Observe the applicable accident protection regulations.
• Security:
Refer to unauthorized persons (children, adolescents) or animals from the  eld of
work/activity.
• Electric impact:
Only hire professional and knowledgeable personnel for the professional and safe
connection of the Conel Flow Rain-Champion.
• Risk of squeezing:
Use only suitable mounting material and /tool. Always wear your personal protecti-
ve equipment (e.B. protective gloves, safety shoes).
• Risk of shock:
Make sure there is enough space and remove any unnecessary items that pose a
risk of shock or stumbling.
7.1.1 Customer-side returns
Note:
• Only have professional and knowledgeable personnel assembling and installing the
Conel Flow Rain-Champion;
• Use suitable lifting and carrying aids;
• Wear your personal protective equipment -/clothing;
• Install the Conel Flow Rain-Champion in a room with a  oor drain;
• The installation of the Conel Flow Rain-Champion requires a connection to the
public sewer network or to a lifting system (emergency over ow);
• For trouble-free and material-friendly operation, the Conel Flow Rain-Champion
recommends the installation of a dimension-appropriate MAG in the pressure line;
• provide fault current circuit breakers with a tripping current of ≤ 30 mA (milliam-
pere);
• appropriate circuit breakers on the building side;
• provide suitable surge protection on the building side;
• provide suitable pipe diameters on the building side;
• provide a maximum of 4 bar form of the drinking water supply line on the building
side (use pressure reducers if necessary);