Conel FLOW - Detailed Inspection and Maintenance Measures

82
12.3 MAINTENANCE
• The functional components of the Conel Flow Rain-Champion are maintenance-free. Nevertheless,
it may happen that maintenance and repairs at the plant are required. Please refer to the instructions
in the following chapter.
Note:
• The service life of the Conel Flow Rain-Champion is highly dependent on the
water quality, especially the rainwater fed in.
12.4 INSPECTION AND MAINTENANCE MEASURES
Regular inspection and maintenance increase operational and functional safety and extend service life.
In the following table you will nd information and measures for the inspection and maintenance of a
rainwater utilization system based on DIN1989-1. We recommend that you follow these instructions to
increase operational and functional safety.
The notes and periods listed in the table are indicative and must be adapted to the respective spatial and
structural operations.
Note:
The service life of the Conel Flow Rain-Champion is highly dependent on the
water quality, especially the rainwater fed in.
• Inspections may be carried out independently or by professional/knowledge-
able personnel or by the manufacturer;
• Maintenance and repairs may only be carried out by professional and know-
ledgeable personnel or by the manufacturer.
• This professional shall have read and understood this operating manual;
• The notes and periods in the table are indicative and must be adapted to the
respective local and outdoor environments.
Plant part/device Measure Implementation Period
Roof drains Inspection Check for unhindered
drain (including any
overows), tightness,
clean dirt catches,
check heating if neces-
sary.
approx. 6 months
Roof gutters /rain drop
pipes
Inspection Check for tightness,
cleanliness, fastening,
clean sift
approx. 6 months
Filter Inspection Control of the condi-
tion
approx. 1 year
Maintenance Cleaning the lter approx. 1 year
Rainwater storage
including components
Inspection Check for cleanliness,
tightness, stability
approx. 1 year
Maintenance Emptying, cleaning of
the inner storage areas,
if necessary removal of
the sediment