Conel FLOW - Troubleshooting Common Issues; Troubleshooting Security Protocols; Error Detection and Initial Fault Measures

80
• Empty the feed-in tank and the pump housing as much as possible – with a  lled tank, the Conel Flow
Rain-Champion has a very high weight.
• Loosen the two fastening screws at the top of the feed tank (see Figure 8.2.3);
• Lift Conel Flow Rain-Champion of the wall rail bracket - use suitable vertical devices.
• Dismantling the wall support bracket from the wall.
Danger from shock and crush injuries
• Always wear your personal protective equipment and be careful when dis-
mantling;
• Empty the feed tank and the pump housing as much as possible – with a  lled
tank, the Conel Flow Rain-Champion has a very high weight - use lowering/
lifting devices for lifting.
11 TROUBLESHOOTING
11.1 SECURITY
• Improper performance of activities during troubleshooting can cause death,
grievous bodily harm and damage to the pump.
• Have all the above-mentioned work carried out only by professional and
knowledgeable personnel.
• This staff must have read and understood these operating instructions.
• Turn the pump off without voltage and secure it against unauthorized or un-
intentional switching on.
• Ensure that the Conel Flow Rain-Champion cannot be used without authori-
zation or unintentionally during troubleshooting;
11.2 ERROR STATE DETECTION
If the Conel Flow Rain-Champion is working incorrectly, this may be noticeable at the following points:
• The pump switching machine displays a fault according to the status display;
• Unusual noises can be heard on the Conel Flow Rain-Champion;
• The electrical safety parts are triggered.
11.3 FIRST MEASURES TO ELIMINATE FAULTS
Check the following circumstances:
• Press the „RESET button“ and acknowledge the fault;
• Check the raw line system for leaks;
• Check water level in the storage?
• If necessary, check  lters in the memory on the suction line and, if necessary, clean them:
• Are all picking points closed?
• Check the electrical r fault current circuit breaker and the associated circuit breaker in the control
cabinet - if necessary switch it back on?
If you are not able to detect any disturbance, please refer to the following chapter“.
11.4 FURTHER MEASURES TO ELIMINATE FAULTS
Note:
• If you cannot locate or repair the fault yourself or if you are unable to  x it,
please contact your electrical/sanitary department or directly to the manufac-
turer (contact details see chapter 1.5).