EasyManua.ls Logo

Continental Fireplaces CB36PTR - User Manual

Continental Fireplaces CB36PTR
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE.
INSTALLATION AND
OPERATING INSTRUCTIONS
CERTIFIED TO CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA 2.22 AND ANSI Z21.50, FOR VENTED DECORATIVE GAS APPLIANCES.
EN
FR
PG
73
FOR INDOOR USE ONLY
SAFETY INFORMATION
! WARNING
If the information in these instructions
are not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
- Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbour‟s phone. Follow the gas
supplier‟s instructions.
If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by a
qualified installer, service agency or the supplier.
This appliance may be installed in an
aftermarket, permanently located, manufactured
home (USA only) or mobile home, where not
prohibited by local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appliance
is not convertible for use with other gases,
unless a certified kit is used.
CB36NTR / CB36NTRE &
CX36NTR-1 / GCX36NTRE-1
NATURAL GAS MODEL
CB36PTR / CB36PTRE &
CX36PTR-1 / CX36PTRE-1
PROPANE GAS MODEL
SAFETY
BARRIER
CB36
ILLUSTRATED
! DANGER
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada / 103 Miller Drive,
Crittenden, Kentucky, USA, 41030 Phone 1 (866) 820-8686 www.continentalfi
replaces.com ask@continentalfi re.on.ca
W415-1679 / D / 03.09.18

Table of Contents

Questions and Answers

  • M
    michelle23Nov 22, 2025
    How to fix a pilot light that will not light on my Continental Fireplaces Indoor Fireplace?
    • S
      Seth RomeroNov 22, 2025
      If the pilot light won't ignite on your Continental Fireplaces Indoor Fireplace, there are several things to check: * First, verify that the sensor wire and igniter wire are connected to the correct terminals on the module (not reversed). * Ensure there are no loose connections, electrical shorts, or grounding issues in the wiring. * Check the igniter spark gap, it should be 1/8” (3.2mm). * Confirm the transformer is installed and plugged into the module, with a voltage between 6.2 and 7.0 volts A.C. when the switch is ON. * If using a battery backup, check the batteries. * Remove and reinstall the wiring harness, verifying continuity of each wire. * Troubleshoot with a simple ON/OFF switch to rule out improper switch wiring. * Ensure the valve and pilot assemblies are pro...
  • T
    Trevor MejiaAug 25, 2025
    What to do if Continental Fireplaces Indoor Fireplace continues to spark and pilot lights, but main burner will not light?
    • A
      alicia96Aug 26, 2025
      If your Continental Fireplaces Indoor Fireplace continues to spark and the pilot light is on, but the main burner won't light, check the following: * Verify all connections are tight and not grounding out to any metal, especially those from the pilot assembly. * Ensure the flame is engulfing the sensor rod to improve flame rectification. * Clean the sensor rod with a fine emery cloth or synthetic scrub pad to remove any accumulated contamination.
  • P
    Peter DavisAug 27, 2025
    Why is the main burner flame blue, lazy, and transparent on my Continental Fireplaces CB36PTR?
    • L
      Lisa MarksAug 27, 2025
      If the main burner flame on your Continental Fireplaces Indoor Fireplace is blue, lazy, and transparent, check for a blockage in the vent and remove it. In extreme conditions, ice buildup may occur on the terminal and should be removed. Also, check the venting system parameters, such as the seal, length, and rise.
  • M
    Ms. Michelle JohnsonAug 27, 2025
    What to do if I smell exhaust fumes and have headaches from my Continental Fireplaces CB36PTR?
    • R
      robertsonrachelAug 28, 2025
      If you smell exhaust fumes in the room or experience headaches when using your Continental Fireplaces Indoor Fireplace, check all seals on the appliance. Also, check if exhaust is re-entering through an open door or window.
  • C
    Christina GreeneAug 29, 2025
    Why are the flames very aggressive on my Continental Fireplaces Indoor Fireplace?
    • Z
      Zachary JohnsonAug 29, 2025
      If the flames on your Continental Fireplaces Indoor Fireplace are very aggressive, first check if the door is ajar and tighten the door clamps if applicable. If the venting action is too great, restrict the vent exit with a restrictor plate.
  • D
    Donald AndersonSep 23, 2025
    Why is there no gas to the main burner on my Continental Fireplaces CB36PTR?
    • P
      Pamela MunozSep 23, 2025
      If the pilot is burning, but there's no gas to the main burner, with the gas knob on ‘HI’ and the wall switch/thermostat on, for your Continental Fireplaces Indoor Fireplace, purge the gas line. Also, check if you are out of propane gas and fill the tank if necessary.
  • R
    Ronald MartinSep 16, 2025
    Why does the pilot go out when the gas knob is released on my Continental Fireplaces CB36PTR?
    • M
      Melissa PerezSep 17, 2025
      If the pilot goes out when the gas knob is released on your Continental Fireplaces Indoor Fireplace, allow approximately 60 seconds for the thermocouple to cool.
  • A
    Ashley YangSep 18, 2025
    Why is there a white film forming on my Continental Fireplaces CB36PTR?
    • N
      Nathaniel SanchezSep 18, 2025
      If you observe a white or grey film forming on your Continental Fireplaces Indoor Fireplace, this is likely sulphur from the fuel being deposited on the glass, logs, or combustion chamber surfaces. Clean the glass.
  • S
    sjohnsonSep 8, 2025
    Why does the pilot light but stop sparking on my Continental Fireplaces CB36PTR?
    • E
      elainewagnerSep 8, 2025
      If the pilot lights but stops sparking, or remains lit but the burner won't turn on in your Continental Fireplaces Indoor Fireplace, inspect all wires to ensure good, tight connections and that they are installed correctly. Inspect the wiring harness, ensuring it's tightly connected to the module and that all wires are in the right order.
  • R
    Ryan ClineSep 5, 2025
    How to fix a pilot light that won't light on a Continental Fireplaces CB36PTR Indoor Fireplace?
    • C
      Corey MorganSep 5, 2025
      If the pilot light won't ignite in your Continental Fireplaces Indoor Fireplace, check the wiring to ensure the sensor and igniter wires are correctly connected to the module. Verify there are no loose connections, electrical shorts, or grounding to metal objects. Ensure the igniter spark gap is 1/8” (3.2mm). Check the transformer is installed, plugged into the module, and has a voltage between 6.2 and 7.0 volts A.C. If using a battery backup, check the batteries. Remove and reinstall the wiring harness, verifying continuity of each wire. Ensure the valve and pilot assemblies are properly grounded to the metal chassis.

Summary

3.0 Venting

3.1 Venting Lengths and Components

Specifies compatible venting components and length limitations for installation.

3.2 Typical Vent Installation

Illustrates standard top and rear vent installation configurations.

3.4 Minimum Air Terminal Location Clearances

Details required clearances for vent terminals in various locations.

4.0 Installation

4.1 Wall and Ceiling Protection

Specifies materials and clearances for protecting walls and ceilings during installation.

4.1.1 Horizontal Installation

Guides through the process of installing horizontal vent runs through walls.

4.1.2 Vertical Installation

Details the steps for installing vertical vent runs through roofs.

4.2 Using Flexible Vent Components

Explains how to use flexible vent pipes for installation.

4.3 Using Rigid Vent Components

Outlines the process for installing rigid vent components.

4.6 Gas Installation

Provides instructions for connecting the gas supply and related safety.

5.0 Framing

5.1 Framing for CB36; CX36-1

General framing guidelines for the specific appliance models.

5.1.1 Minimum Framing Dimensions

Specifies required dimensions for framing the appliance enclosure.

5.2 Minimum Enclosure Clearances

Details required clearances within the appliance enclosure for safe operation.

6.0 Finishing

6.1 Safety Barrier & Door Removal;Installation

Step-by-step guide to removing and installing the safety barrier and glass door.

7.0 Wiring Diagram

7.1 Wiring Requirements

Details electrical connection and grounding requirements based on local codes.

8.0 Operation (Electronic)

9.0 Operation (Millivolt)

10.0 Adjustment

11.0 Maintenance

11.1 Annual Maintenance

Recommended annual service checks and cleaning procedures for the appliance.

15.0 Troubleshooting (Electronic)

17.0 Warranty

Continental Fireplaces CB36PTR Specifications

General IconGeneral
TypeGas Fireplace
StyleTraditional
Fuel TypeNatural Gas or Propane
Ignition SystemElectronic Ignition
Vent TypeDirect Vent

Related product manuals