Need help?Do you have a question about the ControlFreq QUICK-FIT and is the answer not in the manual?
General| Brand | ControlFreq |
|---|---|
| Model | QUICK-FIT |
| Category | Intercom System |
| Language | English |
Safety guidelines for switching on the unit when wireless use is prohibited.
Potential interference issues with wireless phones and units affecting performance.
Instructions to switch off unit near medical equipment due to restrictions.
Instructions to switch off wireless devices in aircraft to prevent interference.
Safety precautions for not using the unit at refueling points or near chemicals.
Safety guidelines for avoiding unit use where blasting operations are in progress.
General advice on using the unit normally and avoiding unnecessary antenna contact.
Indicates GSM signal strength from 1 to 5 flashes (weak to excellent).
Indicates problems with GSM network connection or unit failure.
Indicates GSM module status: ON but not connected, or connected.
Defines parameters for alarm reporting and triggering.
Configures output behavior for alarms and events.
Defines access levels for programming and remote control.
Parameters used to configure various functionalities of the QUICK-FIT GSM.
Allows users to write and send custom SMS messages for alarm inputs.
Details parameters for configuring the intercom functionality for users.
Provides 'free of charge' options for controlling outputs via Caller ID.
Logs specific events like CLIP and alarm inputs, including event type and time.
Commands for controlling special functions via SMS.
Retrieves all currently programmed parameters via SMS.
Retrieves all programmed telephone numbers (TN1-TN5) via SMS.
Retrieves programmed Input filters (ID1-ID4) via SMS.
Retrieves programmed Output parameters (OS1-OS4) via SMS.
Retrieves credit amount on the prepaid SIM card via SMS.
Retrieves the current state of the outputs via SMS.
Manually restarts the GSM module and reboots parameters from SIM.
Retrieves the log on the QUICK-FIT GSM device via SMS.
To Next Page