QUICK‐FITGSM
INSTALLATIONMANUAL
Page25
♦ Remote programming by SMS
;#0HOUSE=1;#1KITCHEN=1;
9.6 INTERCOM
Intercom functionality is supported by a set of parameters, used to tweak the
functionality to each user needs.
For each button QUICK-FIT GSM incorporates a group of parameters. There are up to 8
groups of parameters.
9.6.1 ATN1 to ATN5 parameters (A, B, C, D, E, F, G, H) call buttons 1 – 8
Parameters are the call numbers for intercom application.
9.6.2 RTNA parameter (A, B, C, D, E, F, G, H) Buttons1 – 8 call trip timer
Parameter defines the ring time time-out. RTNx timer is started when the call button is
pressed. If the RTNx timer expires before the GSM voice connection is established then
QUICK-FIT GSM device calls the next number in XTN1-XTN5 call list.
9.6.3 DTMF auto dial functionality
This function is used to provide a support for QUICK-FIT GSM device to be able select
extended numbers via DTMF command.
9.6.3.1 SDNx parameter
Parameter is used to set the DTMF number in auto self select function.
9.6.3.2 SDDx parameter
Parameter is used to set the delay ( in s ) for sending DTMF number in auto self select
function.
9.6.4 Time zone
Time zone support. When both time limits are sets ( TZSx and TZEx ) time zone
functionality is ON. When the current time is in the limits of the time zone parameters
the button event calls the number from xTN1 to xTN4, else button event calls xTN5.
9.6.4.1 TZSx parameter
Parameter is used to configure the start time for the time zone functionality - 24h time
format.
To Next Page
Loading...