QUICK‐FITGSM
INSTALLATIONMANUAL
Page38
11 CHANGING PARAMETERS USING THE SMS COMMAND
All programming parameters for QUICK-FIT GSM can also be sent by SMS command. Each
SMS command should start and stop with semicolon. If the confirmation SMS is needed,
put “+” at the beginning of the command SMS.
The first SMS is SMS with telephone numbers (TN1 – TN4). If you would like to check
which telephone numbers are programmed in QUICK-FIT GSM please use the following
command:
;PTN;
Return SMS is (example):
;TN1=0;TN2=0;
If you would like to enter telephone numbers in to QUICK-FIT GSM you can use the
following example:
;TN1=040713470;TN2=+38643364850;
If you would like to receive confirmation SMS write “+” before SMS command:
;+TN1=040713470;TN2=+38643364850;
Return SMS from QUICK-FIT GSM is:
;TN1=040713470;TN2=+38643364850;
NOTE
You can use the same programming procedure for all parameters.
It is also possible to change different parameters with one SMS. Consider that the SMS
message should not be longer than 160 characters (included space characters).
If you would like to change the following parameters TN1, IN1, IN2, OS1, OS2; ID1, LN1
and CRE and would like to receive confirmation SMS, try next example:
;+TN1=07796178765;IN1=1;IN2=1;OS1=15;OS2=1;ID1=120;LN1=1;
Send SMS message to QUICK-FIT GSM telephone number and in a few seconds you receive
SMS message from QUICK-FIT GSM. The sentence of the SMS must be the same as the one
you have sent to QUICK-FIT GSM before.
To Next Page
Loading...