ControlFreq QUICK-FIT - 10.7 RECEIVE INPUT FILTER VALUE (PID); 10.4 RECEIVE OUTPUT PARAMETERS (POS)

QUICK‐FITGSM
INSTALLATIONMANUAL

Page34
10.7 RECEIVE INPUT FILTER VALUE (PID)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed Input filters (ID1 – ID4):
;PID;
10.1 RECEIVE INPUT FILTER VALUE (POD)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed direct output links (OD1 – OD5):
;POD;
10.2 RECEIVE DELAY BEFORE DIAL VALUE (PDD)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed Input filters (DD1 – DD4):
;PDD;
10.3 RECEIVE ACCESS TELEPHONE NUMBERS (PSL)
By sending this command to QUICK-FIT GSM you receive SMS message with programmed
SL level:
;PSL;
10.4 RECEIVE OUTPUT PARAMETERS (POS)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed Outputs parameters (OS1 – OS4):
;POS;
10.5 RECEIVE ALL PROGRAMMED SMS MESSAGES (P#)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed alarm SMS messages (#0 - #4):
;P#;
10.6 RECEIVE SET UP PARAMETERS VALUE (PPA)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed Setup parameters (TST, MNF…):
;PPA;