ControlFreq QUICK-FIT - 9.9 SPECIAL SMS COMMANDS

QUICK‐FITGSM
INSTALLATIONMANUAL

Page31
♦ Remote programming by SMS
;LOGN=5;LOGI=0;ALC=1;
9.9 SPECIAL SMS COMMANDS
These commands can only be issued only over SMS message, and are used to control
some special functions of QUICK-FIT GSM device.
9.9.1 ORC command
Command is used to control outputs directly via SMS message
9.9.2 SDCLR command
To clear all data on SIM card SDCLR command is used.
9.9.3 LCRL command
Command clears log on QUICK-FIT GSM device.
9.9.4 CLPCLR command
Command is used to delete all CLP numbers.
9.9.5 MRES command
Command is used to manually restart GSM module on QUICK-FIT GSM device.
9.9.6 SSRES command
Command is used to manually restart QUICK-FIT GSM device.
9.9.7 Table of parameters
Name Comment
ORC1 Control of output 1
ORC2 Control of output 2
ORC3 Control of output 3
ORC3 Control of output 4
SDCLR Delete all SIM content