ControlFreq QUICK-FIT - 10 PRINT-OUT OF THE PARAMETERS; 10.1 RECEIVE ALL PARAMETERS (PALL); 10.4 RECEIVE TELEPHONE NUMBERS (PTN)

QUICK‐FITGSM
INSTALLATIONMANUAL

Page33
10 PRINT-OUT OF THE PARAMETERS
The user can check the settings of ALL parameters on the QUICK-FIT GSM.
10.1 RECEIVE ALL PARAMETERS (PALL)
By sending this command to QUICK-FIT GSM you receive SMS messages with all
parameters that are currently programmed in the unit:
;PALL;
10.2 CHECK SW REVISION (PSW)
By sending this command to QUICK-FIT GSM you receive SMS messages with current SW
version running on QUICK-FIT GSM device:
;PSW;
10.3 CHECK SIGNAL QUALITY (PSQ)
By sending this command to QUICK-FIT GSM you receive SMS messages with signal quality
QUICK-FIT GSM device is connected to network:
;PSQ;
10.4 RECEIVE TELEPHONE NUMBERS (PTN)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed telephone numbers (TN1 – TN5):
;PTN;
10.5 RECEIVE LINKS (PLN)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed links (LN1 –LN8):
;PLN;
10.6 RECEIVE INPUT PARAMETERS (PIN)
By sending this command to QUICK-FIT GSM you receive SMS message with all currently
programmed Input parameters (IN1 – IN4):
;PIN;