Moving and setting up the appliance
Installation manual 35
► Taking to the installation location
Space required for conveying the appliance
Make sure that there is enough width and height along the entire route used for conveying the appli-
ance to ensure it can get through to its installation location.
The table below shows the required minimum door size to allow the combi steamer to be brought to its
intended location:
Table-top appliances Floor-standing appliances
6.10 6.20 10.10 10.20 12.20 20.10 20.20
Width
[mm] 1130 1410 1130 1410 1435 1150 1435
Height
[mm] 1002 1085 1270 1290 1596 2132 2138
Load bearing capacity of moving equipment
Provide moving equipment that is rated capable of carrying the load.
The table below shows the minimum load bearing capacity required of the moving equipment:
Table-top appliances Floor-standing appliances
6.10 6.20 10.10 10.20 12.20 20.10 20.20
Weight OEB
[kg] 163 230 192 270 350 357 455
Weight OES
[kg] 156 211 180 255 335 329 433
Weight OGS
[kg] 163 221 188 272 344 355 467
Weight OGB
[kg] 185 248 210 297 380 399 510
The figures refer to appliances including packaging and CONVOClean system. For appliances that do
not have the CONVOClean system you can deduct 5 kg in each case.
Personal protection equipment
Wear personal protection equipment when carrying out the tasks described here:
Safety boots
Hard hat (when heavy loads are being lifted or when working overhead)
To Next Page
Loading...
Need help?
General
