Moving and setting up the appliance
Installation manual 39
► Setting up table-top appliances
Requirements
The following points must be checked when setting up the combi steamer:
The appliance can be placed in the installation position so that it cannot tip over or slide about.
The ventilation holes in the appliance base (2) and the air vent and gas flue pipe on the appliance
top (1) are not covered, blocked or obstructed.
There is no sprinkler or smoke alarm positioned directly above the combi steamer.
All other conditions cited in the section Requirements for the installation location on page 30 are
met.
The following diagram shows the air vent and gas flue pipe (1) and the ventilation holes (2):
1
2
Personal protection equipment
Wear personal protection equipment when carrying out the tasks described here:
Safety boots
Hard hat (when heavy loads are being lifted or when working overhead)
To Next Page
Loading...
Need help?
General
