For your safety
Installation manual 23
► Requirements for safe setup, installation and preparation for first-
time use
Meaning
Safe operation of the combi steamer is only guaranteed if it has first been set up, installed, connected
and prepared for use in accordance with the basic requirements specified here.
Stability
Observe the following requirements to ensure that the combi steamer is installed in a stable situation:
The standing surface must be flat and sufficiently strong to bear the weight of the appliance.
This must include the maximum permissible loading weight for the appliance model concerned.
The height-adjustable feet on the combi steamer must be adjusted to ensure the appliance is posi-
tioned horizontally on the standing surface.
On vehicles and on-board ships, the combi steamer must be suitably anchored to secure it from
tipping over or sliding about.
Installing the connection to the electrical supply
Observe the following requirements to prevent hazards caused by faulty electrical connections:
Only qualified electricians from an approved customer service office are permitted to perform work
on electrical equipment.
The connection to the electrical supply must be installed in accordance with applicable local regula-
tions of the professional associations and power supply company.
The case of the appliance must be grounded in a suitable manner and connected to an equipoten-
tial bonding system.
All electrical connections must be checked when the appliance is prepared for first-time use to
ensure cables are laid correctly and connections are made properly.
Installing the gas supply
Observe the following requirements to prevent hazards caused by faulty connections to gas appli-
ances:
Only approved gas fitters are permitted to connect the combi steamer to the gas supply.
The connection to the gas supply must be installed in accordance with applicable local regulations
of the professional associations and gas supply company.
All gas supply installations must be checked carefully when the appliance is prepared for first-time
use to ensure the connections are gas-tight and installed correctly.
Environmental conditions at the installation location
To ensure safe operation of the appliance, the environmental conditions at the intended installation
location must meet the following requirements:
It is prohibited to store flammable gases or liquids in an area exposed to heat radiated from the
appliance.
It is prohibited to operate deep-fat fryers or appliances that use hot, uncovered fat, in an area that
can be reached by the water jet from the hand shower.
For the operation of gas appliances, there must be a guaranteed, unrestricted supply of fresh air,
and the ventilation system must be installed in accordance with regulations.
To Next Page
Loading...
Need help?
General
