Convotherm OEB 10.10 Installation Manual

Preparing for first-time use, taking out of service and disposal
Installation manual 72
► Procedure for preparing the appliance for first-time use
Meaning
This section is intended for personnel who will prepare the appliance for first-time use. It summarizes
what requirements must be met prior to putting the combi steamer into use, and describes the proce-
dure for preparing the appliance.
Checks prior to preparing the appliance for first-time use
Before preparing the combi steamer for first-time use, check that the following requirements are met:
 The appliance has no signs of damage.
 The appliance has been set up so that it cannot slide about or tip over; the requirements for the
installation position and the area around the appliance have been met (see section Setting up the
appliance on page 44).
Protective films, cardboard packaging and transport securing devices etc. have been removed
completely.
 The appliance is installed in accordance with the requirements in the section Connecting up the
combi steamer on page 44.
Use the Installation checklist to carry out this check.
 All safety devices are in their designated position and are working correctly.
All warning signs are in their designated position.
Use the Safety devices and warnings checklist on page 134 to carry out these checks.
The appliance must not be put into service unless all the specified requirements are met.
First-time use
To prepare the combi steamer for first-time use, follow the steps below:
Step Action Illustration / Further details...
1
Reset the thermal cutout if necessary.
2
Switch on the circuit breaker.
3
Open the water tap(s).
4
OGS/OGB:
 Start the room ventilation system running.
 Open the gas tap.
5 Check that the following are seated properly and in the correct
position:
 Suction panel
 racks
 Loading trolley
6
Check the adjustment of the door catch.
For information on adjusting the
catch, please contact the manufac-
turer, or refer to the service manual.
7
Switch the combi steamer on with the ON/OFF switch.

Convotherm OEB 10.10 Specifications

General

Model	OEB 10.10
Capacity	10 x 1/1 GN
Power Supply	Electric
Cooking Modes	Convection, Steam, Combination
Voltage	400 V
Frequency	50/60 Hz
Temperature Range	30°C to 300°C