Preparing for first-time use, taking out of service and disposal
Installation manual 73
Step Action Illustration / Further details...
8
Set the following:
date
time
Language
Refer to the user manual for instructions on this.
9
Select the Superheated steam cooking program:
Set 150°C and 10 minutes. Refer to the user manual for
instructions on this.
10
Check the following points:
Is the oven light on?
Is the fan running?
Are there any leaks in the water-supply and waste-water
system?
Does the temperature rise inside the oven?
Is steam being generated inside the oven? (Open door
carefully)
11
Check ignition for the following gas burners:
OGS: burner for oven heater
OGB: burner for over heater and burner for steam generator
12
OGS/OGB:
Carry out a flue gas analysis.
Make sure that the flue gas values comply with the figures
specified under Gas installation to a fixed connection on
OGS/OGB appliances on page 58. If not, the bur-
ner/appliance adjustments must be corrected.
Gas installation to a fixed connection
on OGS/OGB appliances on page 58
13
OES and OGS:
Run the appliance in Steam mode.
Use the pressure regulator to adjust the water supply read-
ing for the steam generator to the pressures in the table
below:
OES and OGS Water pressure
6.10, 6.20, 10.10, 10.20,
12.20
100 kPa (1.0 bar)
20.10 and 20.20 180 kPa (1.8 bar)
14
Appliance with automatic cleaning (CONVOClean system):
Start the CONVOClean system.
Check the supply of CONVOClean and CONVOCare.
Customer guidance and instruction.
Instruct the user in all safety-related functions and devices. Instruct the user in how to operate the
appliance.
To do this, follow the procedures given in the following checklists:
Checklist: Customer guidance and instruction - safety on page 135
Checklist: Customer guidance and instruction - operation and maintenance on page 140
To Next Page
Loading...
Need help?
General
