Connecting up the combi steamer
Installation manual 46
Position of the type plate and the electrical connections
The following diagram shows the appliance viewed from the left side, with the wiring compartment
cover removed and fitted respectively:
2
3
4
1
5
Carrying out the electrical installation
Follow the steps below to connect your combi steamer to the electrical supply:
Step Action Illustration
1
Check that the electrical supply ratings on the type plate (3)
match the figures for the building's power supply and those
given in the circuit diagram. It is only permitted to connect the
combi steamer if all these values tally with each other.
The circuit diagram is kept in the wiring compartment (1).
2 Check all screw and clamp connections on the appliance.
There is a risk of connections loosening during transport.
3
Connect the appliance to the designated connection point (5)
on an equipotential bonding system.
4 Use the mains power cord to connect the power supply to the
appliance at the X10 terminal strip (2).
5
Make sure that the cable gland (4) is tightened firmly because
it also acts as a cable strain relief.
6 Fit the cover on the wiring compartment and check that it is
fixed correctly in place.
To Next Page
Loading...
Need help?
General
