Cooper CF1200 - Pre-Alarms

Enter the Supervisor Mode and Select “Pre-Alarms” tab.Enter the Supervisor Mode and Select “Pre-Alarms” tab.
A pre-alarm is shown when a detector appears to register heat or smoke but in a
quantity that is insufficient to warrant an alarm.
Pre-alarm may indicate a build up of dirt in a smoke detector which can be interpreted
by the detector as smoke presence.
A pre-alarm is shown when a detector appears to register heat or smoke but in a
quantity that is insufficient to warrant an alarm.
Pre-alarm may indicate a build up of dirt in a smoke detector which can be interpreted
by the detector as smoke presence.
EvacuateEvacuate
Silence
Alarms
Silence
Alarms
ResetReset
Supervisor
FRE Off
Supervisor
FRE Off
OthersOthers
Fires
AC = 0
Fires
AC = 0
Pre-alarm = Some smoke /heat but below fire threshold
These warnings will appear and disappear
Pre-alarm = Some smoke /heat but below fire threshold
These warnings will appear and disappear
Pre
Alarms
Pre
Alarms
DisabledDisabled
FaultsFaults
Mute
Buzzer
Mute
Buzzer
Pre-AlarmsPre-Alarms
Enter the Supervisor mode and Select the “Disabled” tab.Enter the Supervisor mode and Select the “Disabled” tab.
EvacuateEvacuate
Silence
Alarms
Silence
Alarms
ResetReset
Supervisor
FRE Off
Supervisor
FRE Off
Mute
Buzzer
Mute
Buzzer
OthersOthers
Fires
AC = 0
Fires
AC = 0
Pre
Alarms
Pre
Alarms
DisabledDisabled
FaultsFaults
Addresses: 0Addresses: 0
Touch button to
View list
Touch button to
View list
I/OI/O
Zone: 0Zone: 0
The individual buttons show which devices and the number of devices which have been
disabled. Press one of the buttons to display detailed information for a particular
category
The individual buttons show which devices and the number of devices which have been
disabled. Press one of the buttons to display detailed information for a particular
category
Disabled DevicesDisabled Devices
43