• After using your wheels for the first time, check the wheels’ centering.
• After each ride, check the condition of your tubular or clincher tires, as well as the tire pressure (maximum authorized air
pressure for clincher wheels : 8 bars -120psi).
• Don’t mount tubular or clincher tires with too narrow sections because they may cause damages to your rim.
• Periodically check spokes’ tension and wheels’ centering.
Spoke tension is adjusted from inside the rim (spoke nipple in reversed position) using the specific spoke wrench delivered
with your wheel (not supplied with the AERO+ TUBELESS wheel). Warning! Spoke tension must not exceed the tension
applied during mounting in the factory to avoid irremediably damaging your rim. Due to a high tension of the spokes on
the cassette side of the rear wheel, the tightening / unscrewing of the nipples is delicate. If you need to adjust the trueing
of the wheel, please adjust the spokes on the opposite cassette side of the wheel to avoid damaging the nipples (see
chapter 4).
• In case of a fall or a violent impact, you must have your wheel checked by our technicians.
Any violent impact can lead to damages which are often repairable by our composites after-sales department, but such
repairs will be billed to you.
• To clean your wheel, don’t use any high-pressure water device, especially to clean the hub in which pressurized water
may penetrate and damage the bearings or components of your cassette body for the rear wheel.
Use a cloth to dry your wheel.
• Times and kilometer readings are given for guidelines and can change significantly according to usage conditions and
the intensity of your activity (example: competition, rain, salted roads, etc…).
• Regularly check the wearing status of your wheels and rims. You must not ride your wheels if you notice cracks on the
rim and/or the hub, if the wheel is broken, damaged or if the braking surface is irregular or worn.
• Regarding the wearing status of the rims, have a check performed each season in our workshops to ensure the best
possible control. CORIMA will check the wearing status and will inform you of the reliability of your rims.
To take advantage of the outstanding features of your CORIMA wheel as long as possible, please
strictly
follow the directions of use below:
The resin used to manufacture the rim and more particularly the part on which the tire is set on, resists to a
temperature of 180°C. The pressure in the tire must not exceed 8 bars (120 psi).
You, as user, must pay attention to two phenomena, which can alter the rim’s geometry and more particu-
larly its braking surface:
-
avoid pressures in the tire that are superior to the ones recommended;
-
avoid extensive and prolonged brakings that would put the rim under temperatures that would be over the
ones indicated above.
The damages due to these two phenomena cannot be considered as manufacturing liabilities
and cannot justify an exchange of the wheel under warranty.
• Every 2000-3000 km, or more frequently in bad weather, lubricate your hub axle and grease the pawls of the cassette
body and the notched crown (see chapter 7) High speed grease for precision bearings and plain bearings (grease such as
Kluber Isof
lex Super LDS1
8 type) to prevent from any type of oxidation, aging and corrosion. Don’t use oil which would dilute
the grease of the ball bearings. When setting the external blocking screws, use light locknut glue, the tightening torque must
be 5Nm.
• All our hubs are built with annular bearings (see table “Bearings of CORIMA hubs”, chapter 12)
13 | SERVICING YOUR WHEELS
|
45
|
English
To Next Page
Loading...
