page-38 EVOLUTION COVER
CAUTION
Make sure that the nylon washer is located on the
outside of the outer sleeve.
FIGURE 59: MOUNTING SCREW ON THE SLEEVE
21.
Make sure the sleeve seal on each post is slid
all the way down against the top of the outer
sleeve see Figure 60.
WARNING
Failing to properly position this seal may cause
serious damage to the post mechanism.
FIGURE 60: SLEEVE SEAL INSTALLATION
22.
Install the 3/8″ x 1″ Allen screw with a 7/32″
(5.5 mm) socket previously removed from the
jacks, with the smaller diameter of the
bushing facing down for each post see Figure
61.
FIGURE 61: FASTEN THE SLEEVE TO THE JACK
23.
Make sure the cover is centered. Use a
measuring tape on all four sides and make
sure it is still resting on the foam spacers. If
not, center the cover on all four sides.
24.
Check if all posts are vertically leveled with a
48″ (122 cm) long level. You will need to verify
the front and right sides of each post with the
level.
25.
Next steps show how to install the outer
corner brackets (4). Figure 62 shows the
installation pattern (four brackets, four
corners). Install the first outer corner bracket
on corner number 1 and then keep following
the pattern for the remaining brackets.
240799 OWNER'S MANUAL REVISION 4
To Next Page
Loading...