CPS SCA Series - Arc Parameters

110
4: PF(P) curve
5: Q(U) curve
Percentage(
%)
Local Power Factor Setting
-66.0
0.0
66.0
-66.0
0.0
66.0
PFSetValue
Local Power Factor Setting
-1.0,
-0.8
1.000
0.8,
1.0
-1.0,
-0.8
1.000
0.8,
1.0
6.2.7 Arc Parameters
ARC Parameters is used to enable/disable the ARC function and set the
ARC parameters. These settings are only to be changed by CPS
personnel with approval from the AHJ.
LVRT/HVRT Setup
Setting
P1/2
System Parameters
Protection Parameters
Power Derating Setup
Reactive Power Derating Setup
ARC Parameters
Control Command
ARC Bandwith Setting
ARCEnable
P1/1
Disable
Figure 6-17 Arc Parameters Setting
6.2.8 Other Parameters
Other Parameters is used to set additional parameters including MPPT scan period,
scan period, nominal derating step and GFCI, DCI parameters. Press ENT and use
and use UP/DOWN keys to set parameters and enable/disable the functions. Press