67
3. The inverter will enter Standby mode when the output voltage and power
of PV modules do not meet the startup conditions or PV voltage and input
power are lower than the set value. The inverter will check automatically
whether it meets the startup conditions in this mode until it turns back to
normal mode. The inverter will switch from standby mode to fault mode if
a malfunction occurs.
E-T:0.0kWh
2015-10-22 12：00:00
E-D:0.0kWh
3
6 9 12 15 18 21 24h
15
30
45
60
kWh
Standby Addr:001
PV1:0.0V 0.0A
Figure 4-3 Default Display Interface for Normal Operation
4. If the inverter experiences a Fault it will enter Fault mode and display the
current or most recent faults.
History Record
Running Record
Fault Record
Current Error
Figure 4-4 History Record Interface
To Next Page
Loading...
