Crow PowerWave-16 - Page 68

Page 68
P434E Radio panic mapped to scenario 1-4 default 1 Page 54
P435E
Test calls mapped to scenario 1-4 default 1 Page 54
P436E Duress Alarm mapped to scenario 1-4 default 1 Page 54
P437E Supervised Radio Timeout mapped to scenario 1-4 default 1 Page 54
P438E Zone Inactivity Timeout mapped to scenario 1-4 default 1 Page 54
Low Zone Assignments (Zones 1-8)
P441E
Zone is in Area "A" - Default all ) Page 32
P442E Zone is in Area "B" - Default none ) If zone is in both it is then a partition "C" zone Page 33
P443E Zone is a normally open/closed output - Default N/C off = N/C On = N/O Page 33
P444E
Zone is a radio detector - Default off Page 33
P445E Stay mode zones - Default zones 1-4 Page 33
P446E Zone is isolatable - Default all Page 33
P447E Auto exclude zones - Default all Page 33
P448E
Zone is a handover - Default none Page 33
P449E Two trigger zones -Default none Page 33
P450E Zone is 24Hr - Default none Page 33
P451E
Zone is 24Hr Fire zone - Default none Page 33
P452E Zone is 24Hr Non-Latching zone - Default none Page 33
P453E Day zones - Default none Page 33
P454E
Continuous day zone - Default none Page 34
P455E Siren lockout zones - Default none Page 34
P456E Access control door position input - Default none Page 34
P457E Access control request to exit input - Default none Page 34
** Multiple Zone Activation Reporting **
P458E Zones 1-8 will report multiple activation's - default on Page 34
Zones 1-8 Monitored for Inactivity
P459E Zones 1-8 will be monitored for inactivity - default none Page 34
Cannot Arm if Zone is Unsealed-Zones 1-8
P460E Cannot Arm if Zone Unsealed-Zones 1-8 - default none Page 34
High Zone Assignments (Zones 9-16)
P461E Zone is in Area "A" - Default all Page 34
P462E
Zone is in Area "B" - Default none If zone is in both it is then a partition "C" zone Page 34
P463E Zone is a normally open/closed output - Default N/C off = N/C On = N/O Page 34
P464E Zone is a radio detector - Default off Page 35
P465E Stay mode zones - Default zones none Page 35
P466E
Zone is isolatable - Default all Page 35
P467E Auto exclude zones - Default all Page 35
P468E Zone is a handover - Default none Page 35
P469E
Two trigger zones -Default none Page 35
P470E Zone is 24Hr - Default none Page 35
P471E Zone is 24Hr Fire zone - Default none Page 35
P472E Zone is 24Hr Non-Latching zone - Default none Page 35
P473E
Day zones - Default none Page 35
P474E Continuous day zone - Default none Page 35
P475E Siren lockout zones - Default none Page 35
P476E
Access control door position input - Default none Page 36
P477E Access control request to exit input - Default none Page 36
** Multiple Zone Activation Reporting **
P478E Zones 9-16 will report multiple activation's - default on Page 36
Zones 9-16 Monitored for Inactivity
P479E Zones 9-16 will be monitored for inactivity - default none Page 36
Cannot Arm if Zone is Unsealed-Zones 9-16
P480E
Cannot Arm if Zone Unsealed-Zones 9-16 - default none Page 36