Crow PowerWave-16 - Page 67

Page 67
8 =
Control/Chime disables day zones
P402E Misc partitions options 2 - Default 3,4,6 1 = Key-switch enabled Page 28
2 = Use 2nd Key-switch
3 = Key-switch ARM's/STAY
4 = Pendant chirps when armed
5 = Pendant chirps when in Stay Mode
6 = 2 sec pulse at set
7 = 2 sec pulse at unset
8 = Access control even when armed
P403E PARTITION "B" TIME AND DELAY OPTIONS Page 26
1 = Set partition When Time Zone Ends
2 = Unset Partition When Time Zone Starts
3 = Disable Stay Mode Exit Delay
4 = Disable Set Mode Exit Delay
5 = Disable Stay Mode Entry Delay
6 = Disable Set Mode Entry Delay
7 = Use special Stay Mode entry timer
8 = Report Stay Mode alarms & Bypasses via dialer
Soak-Test Zones
P408E SOAK-TEST ZONES - 1-8 Page 32
P409E SOAK-TEST ZONES - 9-16 Page 32
Single or Dual Zone Input (8 or 16 Zones)
P410E Single or dual zone input - Default-All Off (zones 1-8 only) Page 32
Vibration Sensor Zone Sensitivity Settings (Zones 1-8)
P411E Zone 1 vibration sensitivity - Default 0 0 = No vibration sensor Page 31
P412E
Zone 2 vibration sensitivity - Default 0 Sensitivity 1-8 Page 31
P413E Zone 3 vibration sensitivity - Default 0 1 = High sensitivity Page 31
P414E Zone 4 vibration sensitivity - Default 0 8 = Low sensitivity Page 31
P415E Zone 5 vibration sensitivity - Default 0 Page 31
P416E
Zone 6 vibration sensitivity - Default 0 Page 31
P417E Zone 7 vibration sensitivity - Default 0 Page 31
P418E Zone 8 vibration sensitivity - Default 0 Page 31
Zone End of Line Options
P419E Zone End-of-Line Options default = Page 32
Zone Response Time Settings
P420E Zone response settings default = 6 (value 1-31E) Page 31
** System Events to Scenario Mapping
**
P421E
Area A reports mapped to scenario 1-4 default 1 Page 53
P422E Area B reports mapped to scenario 1-4 default 1 Page 53
P423E Area C reports mapped to scenario 1-4 default 1 Page 53
P424E
Keypad “Panic” (& buttons 1 & 3) mapped to scenario 1-4 default 1 Page 53
P425E Keypad “Fire” (buttons 4 & 6) mapped to scenario 1-4 default 1 Page 53
P426E Keypad “Medical” (buttons 7 & 9) mapped to scenario 1-4 default 1 Page 53
P427E Battery low mapped to scenario 1-4 default 1 Page 53
P428E
Mains fail mapped to scenario 1-4 default 1 Page 53
P429E Phone line restore mapped to scenario 1-4 default 1 Page 53
P430E Radio PIR battery low mapped to scenario 1-4 default 1 Page 53
P431E
Radio key battery low mapped to scenario 1-4 default 1 Page 53
P432E Keypad tamper mapped to scenario 1-4 default 1 Page 53
P433E Cabinet tamper mapped to scenario 1-4 default 1 Page 53