Page 17
FULL LCD KEYPAD ADJUSTMENTS
ADJUSTING THE LCD KEYPAD BACKLIGHTING
The installer can adjust the backlight level of each LCD display and the keypad button backlight levels by program-
ming the required value at P95E in the main control panel.
The value is a range from 0-100%.
If set to 0 both the LCD and the keypad button backlighting will be off.
If set to 100 both will be set to the maximum.
The program option is P95E 01-32E (for keypad # 1-32) 0-100E (0-100%)
ADJUSTING THE KEYPAD BUZZER TONE – FULL LCD
To change the buzzer frequency and hence volume on the FULL LCD Keypad you must follow the instructions be-
low;
Press and hold down the <CONTROL> button then within 2 seconds press the <1> button to increase the frequency
or press the <2> button to decrease the frequency.
To move through the different frequencies you have to continue to hold down the <CONTROL> button and press and
release either the <1> or <2> button to move through the different settings.
DISPLAY IP & MAC ADDRESS AT THE KEYPAD
When the panel is in normal mode (ie not in program mode) it is possible to display the currently assigned IP address
for the panel and the MAC address.
To view the MAC Address
At the LCD keypad press and hold the <8> button for 4 seconds until the display shows the panels MAC address. To
exit the display mode press the <ENTER> button.
To view the IP Address
At the LCD keypad press and hold the <9> button for 4 seconds until the display shows the panels IP address. To
exit the display mode press the <ENTER> button.
To Next Page
Loading...
