Page 94
Telephone Number Reporting Options
P183E 1-8E Telephone Number Reporting Options Page 69
(Default = 1,2) 1 = Stop Dialling if Kissed off
2 = Monitor Call Progress
3 = Blind Dial
4 = Use Group Numbers for Contact ID Reporting
5 = Stay On-line after Alarm report for Audio Listen-in
6 = Spare
7 = Use the Dialling Pre-fix
8 = Spare
Maximum Dial Attempts per Telephone Number
P184E 1-8E Maximum Dial Attempts per Telephone Number - Value 0-99 (Default = 20) Page 70
Dialler Reporting Options A
P186E 1-8E Dialler Options A 1 = Report Mains Failure Page 70
(Default = All On) 2 = Report Battery low
3 = Report Radio Battery Low
4 = Report Line Fail
5 = Report System Tamper
6 = Report Keypad Tamper
7 = Report Zone Tamper
8 = Report Radio Zone Tamper
Dialler Reporting Options B
P187E 1-8E Dialler Options B 1 = Report Duress Alarm Page 70
(Default = All On) 2 = Report Supervised Radio Alarm
3 = Report Zone Sensor-watch Alarm
4 = Report Manual Panic Alarm
5 = Report Manual Fire Alarm
6 = Report Manual Medical Alarm
7 = Report Radio Pendant Panic Alarm
8 = Report Zone Bypasses
Dialler Reporting Options C
P188E 1-8E Dialler Options C 1 = Report Arm/Disarm Page 71
(Default = 1,6,8) 2 = Report Stay Mode Arm/Disarm
3 = Report Disarm only after an Activation
4 = Report Stay Mode Disarm only after an Activation
5 = Report Stay Mode Zone Alarms
6 = Report Access to Program Mode
7 = Report 24 Hour Alarms when set to Domestic/Voice mode
8 = Report Zone Restores
Dialler Reporting Options D
P189E 1-8E Dialler Options D 1 = Report Latchkey Disarm Page 71
(Default = 3,4,5 2 = Report Delinquent
3 = Report Tests
4 = Report Fuse Failure
5 = Report Output 1 or 2 Fail
6 = Report RTC Time changed
7 = Report Keypad Buss Trouble
8 = Report RF Interference (Jamming) Detected
+++++SIA Alarm Report Codes+++++
(SIA event codes are entered by programming a value from the chart on Page 115. For example, to send the SIA “Panic
Alarm” code when a keypad panic is generated you must enter a value of “6” at location P197E1E)
Zone Alarm SIA Reporting Codes
P196E 1-64E Zone Alarm SIA Reporting Code - (Default value = 1, Alarm Event Code BA) Page 73
“Panic” Alarm SIA Reporting Code
P197E 1E “Panic” Alarm SIA Reporting Code - (Default value = 6, Panic Alarm Event Code PA) Page 73
“Fire” Alarm SIA Reporting Code
P197E 2E “Fire” Alarm SIA Reporting Code - (Default value = 4, Fire Alarm Event Code FA) Page 73
“Medical” Alarm SIA Reporting Code
P197E 3E “Medical” Alarm SIA Reporting Code - (Default value = 5, Medical Alarm Event Code MA) Page 73
+++++Panel Diagnostic & Default Options+++++
Display Panel Software Version Number
P200E 1E Display the Panel Software Version Number Page 73
To Next Page
Loading...
